Subject	Re: It wasn't the 'hard break in'
Posted by	MaxxAction on December 11, 2013 at 10:22 AM
	This message has been viewed 279 times.
In Reply To	It wasn't the 'hard break in' posted by ThisIsSparTTa on December 10, 2013 at 12:12 PM
Message	If anything... you probably took it too easy on break in. Rings need some pressure to seat well in most situations. When I spoke to Wiseco about my issue, the tech guy told me that he gets the motor started, checks for leaks, gets the cooling system in order, and heads to the dyno for break in with flat out dyno pulls.
Follow Ups	Is my rebuild borked? Ideas, please - ThisIsSparTTa 21:36:19 12/05/13 Confirm your timing belt is set correctly - ttsmokin 22:11:19 12/05/13 Can I run compression test while working on timing belt? - ThisIsSparTTa 07:55:15 12/06/13 Yeah you can - -Grimm- 09:00:07 12/06/13 If you are doing a compression test only, leave the cas - Krazyd27(Houston) 10:48:24 12/06/13 now would be a good time for a leak down test (n/m) - aliaZ 22:19:37 12/06/13 Re: Is my rebuild borked? Ideas, please - MaxxAction 16:02:07 12/07/13 WOT, charged battery, no plugs in. Could be my tester? (n/m) - ThisIsSparTTa 08:35:25 12/08/13 that isn't right - aliaZ 17:42:58 12/08/13 Re: that isn't right - MaxxAction 08:49:59 12/09/13 FWIW - aliaZ 12:53:46 12/09/13 Kyle's builds are supposed to give you between 120-140 psi - Stanky 21:34:41 12/07/13 I agree with ttsmokin, count the timing belt teeth - ZaXxon 04:27:09 12/08/13 Re: Is my rebuild borked? Ideas, please - WazTTed 14:40:21 12/08/13 No safety boost solenoids. No codes. New det sensor (n/m) - ThisIsSparTTa 08:19:49 12/09/13 Re: Is my rebuild borked? Ideas, please - coreymbassett 07:57:11 12/10/13 It wasn't the 'hard break in' - ThisIsSparTTa 12:12:27 12/10/13 Re: It wasn't the 'hard break in' - MaxxAction 10:22:26 12/11/13 I'm not sure of any 'best' break in practice - -Grimm- 10:35:04 12/11/13 10W-30 Dino, Other work I did... - ThisIsSparTTa 11:39:33 12/12/13 That's the hard break-in. Would have been ideal, but... - ThisIsSparTTa 11:40:55 12/12/13 'Hard Break In' doesn't have to occur at a distinct point - -Grimm- 12:41:12 12/12/13 Some Updates - ThisIsSparTTa 08:52:44 01/02/14
Post a Followup	You cannot reply to this message because you are not logged in.