Subject	Re: Injector failure ????
Posted by	ZUL8TR on December 10, 2013 at 5:53 AM
	This message has been viewed 125 times.
In Reply To	Injector failure ???? posted by zx299 on December 08, 2013 at 03:45 AM
Message	Check the condition of the wires for corrosion. When I replaced high omed and failed injectors to 93+ type I found green corroded wires when redplacing the connectors. Corrosion increases resistence with amp load. Switch out bad cylinder with a coil another coil to test. If you pull the plenum dremel it for no plenum pull in the future. ZUL8TR in Orlando,FL
Follow Ups	Injector failure ???? - zx299 03:45:58 12/08/13 Have you ohmed the injector? (n/m) - ThisIsSparTTa 08:30:59 12/08/13 Done.... - zx299 17:22:03 12/08/13 Re: Injector failure ???? - ZUL8TR 05:53:12 12/10/13 New connectors fitted with Sards... - zx299 17:51:39 12/10/13
Post a Followup	You cannot reply to this message because you are not logged in.