Subject	My Works GT-Cs are marked the same ...
Posted by	DaZedMan on December 06, 2013 at 1:41 PM
	This message has been viewed 221 times.
In Reply To	Help identifying wheel offset posted by JMartz on December 04, 2013 at 02:53 PM
Message	but they are drilled for 5x114.3 and fit my Z perfectly. A second set of GT-Cs that I looked at were also marked this way. I saw a note somewhere that it isn't uncommon for this to be the case. Easiest way to determine offset: Lay wheel in flat surface. put straight edge on upper surface of tire. Measure total distance from bottom to top surface (distance "A"). Measure distance from top surface to mounting surface (distance "B"). offset = (A - 1)/2 -B Use A - 1 since the rim width is generally 1/2" smaller on each side than the overall width. If your tires are way wider than the rim, increase the amount you subtract from A.
Follow Ups	Help identifying wheel offset - JMartz 14:53:14 12/04/13 The 5x100 is the lug pattern - ZXRider 15:05:17 12/04/13 Wheels are currently mounted in my Z - JMartz 15:15:36 12/04/13 In that case it makes no sense - ZXRider 15:56:24 12/04/13 Likely a mistake of some sort. - JMartz 16:36:15 12/04/13 Can you measure the diameter of the stud holes? - ZXRider 16:42:01 12/04/13 The holes and the studs are perfectly aligned. - JMartz 17:07:11 12/04/13 Good luck. (n/m) - ZXRider 17:09:46 12/04/13 how much would you like for said rims? :3 (n/m) - Zvil (FL) 07:08:43 12/05/13 Re: how much would you like for said rims? :3 - JMartz 07:04:29 12/06/13 The studs on the Z are 12mm - ZXRider 16:52:00 12/04/13 My Works GT-Cs are marked the same ... - DaZedMan 13:41:22 12/06/13
Post a Followup	You cannot reply to this message because you are not logged in.