Subject	nice, but a few suggestions
Posted by	aliaZ on December 05, 2013 at 7:51 AM
	This message has been viewed 596 times.
In Reply To	VG30DE(TT) Short Block Assembly posted by -Grimm- on December 04, 2013 at 02:15 PM
Message	I always double check the machine shop's work. I'd add steps for measuring cylinder bore taper and out-of-round. I once had a machine shop that managed to make my cylinders oval by .002" Had I not checked this, the engine would have been an oil burner. The machine shop gave me a refund, FWIW
Follow Ups	VG30DE(TT) Short Block Assembly - -Grimm- 14:15:35 12/04/13 Vote to FAQ!!! Great job! - SammybTT(TN) 16:03:52 12/04/13 Nice! (n/m) - doug8867 18:23:08 12/04/13 nice, but a few suggestions - aliaZ 07:51:37 12/05/13 Great point about double checking the work - SammybTT(TN) 09:57:24 12/05/13 The site 'rebuild' document is taken from - -Grimm- 10:27:24 12/05/13 Thanks Steve I went back and reviewed my - SammybTT(TN) 12:00:35 12/08/13
Post a Followup	You cannot reply to this message because you are not logged in.