Subject	The holes and the studs are perfectly aligned.
Posted by	JMartz on December 04, 2013 at 5:07 PM
	This message has been viewed 188 times.
In Reply To	Can you measure the diameter of the stud holes? posted by ZXRider on December 04, 2013 at 04:42 PM
Message	There has to be a casting mistake on the wheel face. All those parts in the car origianal OEM. My interest is mostly to find out what the offset is. I am trying to sell the wheels and I want to be accurate. I just need to measure the offset. Just watched a tutorial on youtube. Should already have done that. Thanks for your input.
Follow Ups	Help identifying wheel offset - JMartz 14:53:14 12/04/13 The 5x100 is the lug pattern - ZXRider 15:05:17 12/04/13 Wheels are currently mounted in my Z - JMartz 15:15:36 12/04/13 In that case it makes no sense - ZXRider 15:56:24 12/04/13 Likely a mistake of some sort. - JMartz 16:36:15 12/04/13 Can you measure the diameter of the stud holes? - ZXRider 16:42:01 12/04/13 The holes and the studs are perfectly aligned. - JMartz 17:07:11 12/04/13 Good luck. (n/m) - ZXRider 17:09:46 12/04/13 how much would you like for said rims? :3 (n/m) - Zvil (FL) 07:08:43 12/05/13 Re: how much would you like for said rims? :3 - JMartz 07:04:29 12/06/13 The studs on the Z are 12mm - ZXRider 16:52:00 12/04/13 My Works GT-Cs are marked the same ... - DaZedMan 13:41:22 12/06/13
Post a Followup	You cannot reply to this message because you are not logged in.