Subject	The studs on the Z are 12mm
Posted by	ZXRider on December 04, 2013 at 4:52 PM
	This message has been viewed 185 times.
In Reply To	Likely a mistake of some sort. posted by JMartz on December 04, 2013 at 04:36 PM
Message	a free fit clearance hole is 15mm. Overlaying the 5x100 on the 5x114.3 I get a an overlap of 0.25" or 6.35mm which clearly isn't enough for the stud to go through. It is definitely a mistake by SSR putting 5x100 on it. Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	Help identifying wheel offset - JMartz 14:53:14 12/04/13 The 5x100 is the lug pattern - ZXRider 15:05:17 12/04/13 Wheels are currently mounted in my Z - JMartz 15:15:36 12/04/13 In that case it makes no sense - ZXRider 15:56:24 12/04/13 Likely a mistake of some sort. - JMartz 16:36:15 12/04/13 Can you measure the diameter of the stud holes? - ZXRider 16:42:01 12/04/13 The holes and the studs are perfectly aligned. - JMartz 17:07:11 12/04/13 Good luck. (n/m) - ZXRider 17:09:46 12/04/13 how much would you like for said rims? :3 (n/m) - Zvil (FL) 07:08:43 12/05/13 Re: how much would you like for said rims? :3 - JMartz 07:04:29 12/06/13 The studs on the Z are 12mm - ZXRider 16:52:00 12/04/13 My Works GT-Cs are marked the same ... - DaZedMan 13:41:22 12/06/13
Post a Followup	You cannot reply to this message because you are not logged in.