TwinTurbo.NET: Nissan 300ZX forum - Can you measure the diameter of the stud holes?
People Seeking Info
 
   


     
Subject Can you measure the diameter of the stud holes?
     
Posted by ZXRider on December 04, 2013 at 4:42 PM
  This message has been viewed 197 times.
     
In Reply To Likely a mistake of some sort. posted by JMartz on December 04, 2013 at 04:36 PM
     
Message I am really curious if the lug pattern is infact 5x100 and yet can be "installed" on the 5x114.3

I quickly modeled up both lug patterns with 12mm holes and the holes do infact overaly each other.

I am not sure on the offset, I have Enkie wheels on my Z and they clearly state the offset stamped in the back. Hopefully someone familiar with SSR wheels can pitch in.

Buy Zama Posters Here

I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM

Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM

P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM

LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.