Subject	They do not know the Z car lifting points. I would have
Posted by	CmyZ on November 19, 2013 at 10:31 PM
	This message has been viewed 170 times.
In Reply To	Shop bent that rail you put jacks on, how bad is that? posted by Metacom on November 19, 2013 at 09:42 PM
Message	them repair that and make sure they do it right. That is messed up. Hammer it is out of the questions it has to be pulled out. That is not a lifting point. The are in the picture is not a reinforced area.
Follow Ups	Shop bent that rail you put jacks on, how bad is that? - Metacom 21:42:59 11/19/13 They do not know the Z car lifting points. I would have - CmyZ 22:31:56 11/19/13 Re: They do not know the Z car lifting points. I would have - Metacom 23:40:52 11/19/13 No it's fine.. - Cjw3 07:13:12 11/20/13 Re: Shop bent that rail you put jacks on, how bad is that? - darkmann 10:09:54 11/24/13
Post a Followup	You cannot reply to this message because you are not logged in.