Subject	O2 sensor replacement
Posted by	rudeboi805 on November 19, 2013 at 3:00 AM
	This message has been viewed 183 times.
Message	So I'm gearing up to swap my oxygen sensors on my 92TT. What I'm trying to figure out is where do I pull the sensors from? Can I access the sensors from the engine bay or do I have to jack it up? Anyone have any pictures of the sensors (in their position in the car--I know what they look like) so I don't have to spend 48 hours trying to find them
Follow Ups	O2 sensor replacement - rudeboi805 03:00:40 11/19/13 Re: O2 sensor replacement - 1bad300t.t. 08:54:58 11/19/13 Can drivers side from the top with extension, etc. - Woody75 (Denver) 09:43:35 11/19/13 They aren't hiding... - ThisIsSparTTa 09:12:52 11/19/13 Take a look at the pre-cat gutting tech article - spicyZ 09:37:55 11/19/13 Not too hard if they are not frozen. I would use some - CmyZ 21:39:58 11/19/13 Freezing spray can help too - used that once with good - jzack 18:43:21 11/20/13 Second on letting the PB Blaster work overnight. - doug8867 06:31:54 11/21/13 I worked it from the topside - dan93z 10:25:55 11/22/13
Post a Followup	You cannot reply to this message because you are not logged in.