Subject	No power to Coil Packs with new ECU.
Posted by	Retro-Cow on November 13, 2013 at 12:59 PM
	This message has been viewed 272 times.
Message	So I just completed a plenum pull, 300 degree fuel rail install and nismo 740cc injectors. I also installed an Ash spec ECU but the coil packs don't get power. It's getting fuel and air perfectly fine. It also sparks and starts fine with the stock ECU but obviously runs rich. Some info about the car that may help in determining the problem, it started as an automatic and I did a 5 speed swap on it. I used the "conversion" harness from z1 and I didn't wire the clutch to anything and I bypassed the starter relay. This may have something to do with it? Also, the ASH-Spec ECU is a manual ECU and my stock one is the Automatic. Again it starts fine with the Automatic ECU. Any help would be greatly appreciated.
Follow Ups	No power to Coil Packs with new ECU. - Retro-Cow 12:59:48 11/13/13 Look up the 300ZX ECCS - -Grimm- 14:09:02 11/13/13 Re: Look up the 300ZX ECCS - Retro-Cow 18:46:39 11/13/13 Re: Look up the 300ZX ECCS - Retro-Cow 19:17:58 11/13/13 Re: No power to Coil Packs with new ECU. - HKS Z32 15:34:25 11/14/13 They should still be receiving power - -Grimm- 16:31:00 11/14/13 Re: They should still be receiving power - Retro-Cow 01:20:16 11/18/13 From a longevity standpoint... - -Grimm- 12:37:28 11/18/13
Post a Followup	You cannot reply to this message because you are not logged in.