Subject	Wish you would have said something last night!
Posted by	-Grimm- on November 12, 2013 at 9:59 AM
	This message has been viewed 197 times.
In Reply To	Re: Main Clearances posted by Tech@EPR on November 12, 2013 at 03:16 AM
Message	Your input is always appreciated. I shimmed it last night and now my clearances are measuring: F->R 0.0016 0.0016 0.0015 0.0016 At least they're more consistent. This was with a little oil on them (couple drops of assembly lube per, wiped on with a clean rag) So now, do I leave it as is (with the foil shims) or do I take them out and run it how it was before? Also, as a side note, I can not find the oil squirter gaskets anywhere. Is there any problem with putting them on with an extremely thin film of RTV? everything is dry (hot tanked)
Follow Ups	Main Clearances - -Grimm- 22:50:32 11/10/13 I'd tighten up the Center two, to the 0016/0018 range (n/m) - Cjw3 06:47:36 11/11/13 Re: Main Clearances - Cjw3 13:45:27 11/11/13 I think I'll take the suggestion (ERP suggested it too) - -Grimm- 15:00:11 11/11/13 Make the Shim as wide and about 75% the length - Cjw3 15:43:11 11/11/13 Re: Main Clearances - Tech@EPR 03:16:16 11/12/13 Wish you would have said something last night! - -Grimm- 09:59:33 11/12/13 Re: Wish you would have said something last night! - Cjw3 11:56:50 11/12/13 Re: Re: Wish you would have said something last night! - Tech@EPR 00:59:58 11/13/13 Well its all together right now - -Grimm- 09:41:52 11/13/13 I went 14 and 16 on my shimmed mains. (n/m) - Cjw3 10:18:02 11/13/13 those clearances are fine for your intended use (n/m) - aliaZ 17:09:25 11/13/13 How about these Rod Clearances - -Grimm- 09:15:46 11/15/13
Post a Followup	You cannot reply to this message because you are not logged in.