Subject	I think I'll take the suggestion (ERP suggested it too)
Posted by	-Grimm- on November 11, 2013 at 3:00 PM
	This message has been viewed 217 times.
In Reply To	Re: Main Clearances posted by Cjw3 on November 11, 2013 at 01:45 PM
Message	to shim the bearing with a strip of aluminum foil and recheck the clearances. If the aluminum foil is ~3 tenths, that should put me at the max of the range, which I will be fine with. (actually I'm fine with 0.0025 but hey, why not get them nearer)
Follow Ups	Main Clearances - -Grimm- 22:50:32 11/10/13 I'd tighten up the Center two, to the 0016/0018 range (n/m) - Cjw3 06:47:36 11/11/13 Re: Main Clearances - Cjw3 13:45:27 11/11/13 I think I'll take the suggestion (ERP suggested it too) - -Grimm- 15:00:11 11/11/13 Make the Shim as wide and about 75% the length - Cjw3 15:43:11 11/11/13 Re: Main Clearances - Tech@EPR 03:16:16 11/12/13 Wish you would have said something last night! - -Grimm- 09:59:33 11/12/13 Re: Wish you would have said something last night! - Cjw3 11:56:50 11/12/13 Re: Re: Wish you would have said something last night! - Tech@EPR 00:59:58 11/13/13 Well its all together right now - -Grimm- 09:41:52 11/13/13 I went 14 and 16 on my shimmed mains. (n/m) - Cjw3 10:18:02 11/13/13 those clearances are fine for your intended use (n/m) - aliaZ 17:09:25 11/13/13 How about these Rod Clearances - -Grimm- 09:15:46 11/15/13
Post a Followup	You cannot reply to this message because you are not logged in.