Subject	fwiw, I always do a leakdown on a new motor I'm assembling
Posted by	aliaZ on November 04, 2013 at 12:55 PM
	This message has been viewed 149 times.
In Reply To	Re: try loosening the cam caps to verify the valve height posted by MaxxAction on November 03, 2013 at 01:00 PM
Message	while it is still on the stand. And then I baseline the compression after it is installed. Otherwise you don't know if a problem existed all along, or if something went wrong during break-in.
Follow Ups	Setting valve height with motor in car?? - MaxxAction 20:48:24 11/01/13 Nope. - Cjw3 08:54:17 11/02/13 Re: Nope. - MaxxAction 15:17:20 11/02/13 try loosening the cam caps to verify the valve height - aliaZ 07:30:27 11/03/13 Re: try loosening the cam caps to verify the valve height - MaxxAction 13:00:41 11/03/13 Re: Re: try loosening the cam caps to verify the valve height - Tech@EPR 02:50:26 11/04/13 fwiw, I always do a leakdown on a new motor I'm assembling - aliaZ 12:55:40 11/04/13 Re: fwiw, I always do a leakdown on a new motor I'm assembling - MaxxAction 17:59:15 11/04/13 Re: fwiw, I always do a leakdown on a new motor I'm assembling - Tech@EPR 23:17:12 11/04/13
Post a Followup	You cannot reply to this message because you are not logged in.