Subject	Not if your scan program says 25*, it must read 15* also
Posted by	ttsmokin on November 01, 2013 at 10:20 AM
	This message has been viewed 202 times.
In Reply To	Re: Re: Check your TPS Voltage.. posted by Rasta420 on November 01, 2013 at 10:06 AM
Message	Then yes move the CAS until you see 15*, use the coil pack wires leading to cylinder #1 for best results. Even better is to make a jumper spark plug lead between the #1 spark plug and its coil pack, this will give the most accurate timing readings with the light.
Follow Ups	Timing question - Rasta420 19:03:14 10/31/13 Yes. You check for 15 by clipping the looped black wire - ThunderZ 19:26:31 10/31/13 Re: Yes. You check for 15 by clipping the looped black wire - Rasta420 20:20:48 10/31/13 Re: Re: Yes. You check for 15 by clipping the looped black wire - Rasta420 20:21:40 10/31/13 Yes. (n/m) - ThunderZ 20:29:24 10/31/13 Re: Timing question - Rasta420 20:28:01 10/31/13 Check your TPS Voltage.. - Cjw3 21:09:12 10/31/13 Re: Check your TPS Voltage.. - Rasta420 07:26:24 11/01/13 Re: Re: Check your TPS Voltage.. - Rasta420 10:06:56 11/01/13 Re: Re: Re: Check your TPS Voltage.. - Cjw3 10:17:22 11/01/13 Re: Re: Re: Re: Check your TPS Voltage.. - Rasta420 10:19:36 11/01/13 Not if your scan program says 25*, it must read 15* also - ttsmokin 10:20:21 11/01/13 Re: Not if your scan program says 25*, it must read 15* also - Rasta420 10:26:33 11/01/13 Re: Re: Not if your scan program says 25*, it must read 15* also - Rasta420 10:35:52 11/01/13
Post a Followup	You cannot reply to this message because you are not logged in.