Subject	Bleeding the Clutch
Posted by	mypak6 on October 27, 2013 at 2:02 AM
	This message has been viewed 172 times.
Message	i've Read the posts on bleeding the clutch after install of engine rebuild. I had similar issue, lost my clutch while going to third gear crossing the highway. clutch wouldnt engage to change gears and was stuck in neutral. opened the master cylinder and saw it was empty. after reading the posts i opened the system applied more DOT3, gravity bled then bled and refilled the lines and again bled from both bleed points. Got the clutch to operate again. drove around without issue but as soon as i tried to go WOT on the Highway i lose the clutch. i dont see any leaks inside the cabin. if i have a leak where else could i lose fluid?
Follow Ups	Bleeding the Clutch - mypak6 02:02:47 10/27/13 master, slave or a line (n/m) - 300ZMang 09:43:47 10/27/13 Slave cylinder is a good starting point to check. Has the - jzack 09:49:55 10/27/13 Re: Slave cylinder is a good starting point to check. Has the - mypak6 16:17:14 10/27/13 Per the other posting below - could be a line, especially - jzack 20:56:58 10/27/13
Post a Followup	You cannot reply to this message because you are not logged in.