Subject	The 10 MM Bolt?
Posted by	Cjw3 on October 26, 2013 at 6:14 PM
	This message has been viewed 214 times.
In Reply To	1990 TT Z Plenum pull, drivers side egr bolt? posted by TheDevilZX on October 26, 2013 at 05:59 PM
Message	I use an 'Articulated' Long Handle 3/8 Drive ratchet.. bend it back on itself like a Crows Foot.. 10 MM Socket Pointed Up.. Point the Handle Up also.. then use a Pair of Vice Grips to complete the Set up.. I end up using my Left hand to hold the Ratchet to the lower part of the plenum, and the Right Arm is above the Plenum Using the Vicegrip on the Ratchet, like a Ratchet Handle.. I have just located a Articulated 1/4 Drive Ratchett, from Autozone, but the handle is too Short to fold back and have it reach above the Plenum, for the Vicegrips to bit on.. Guess I take the Welder to this ratchet, and make it a Custom 300 Tool. I have a Few of them.. Cj
Follow Ups	1990 TT Z Plenum pull, drivers side egr bolt? - TheDevilZX 17:59:05 10/26/13 The 10 MM Bolt? - Cjw3 18:14:11 10/26/13 Re: The 10 MM Bolt? - TheDevilZX 18:30:46 10/26/13 Re: Re: The 10 MM Bolt? - Cjw3 18:43:14 10/26/13 Here is a Pic - Cjw3 18:38:07 10/26/13 Re: Here is a Pic - TheDevilZX 18:42:31 10/26/13 i used a combination of tools - Khronik 19:34:44 10/26/13 Re: i used a combination of tools - TheDevilZX 20:11:12 10/26/13 I used a mini 10 mm wrench, no issues reaching it. Got one? - ThunderZ 22:20:11 10/26/13 This is what I used when I still had EGR (n/m) - MrOzzie5183 22:19:29 10/27/13 Re: 1990 TT Z Plenum pull, drivers side egr bolt? - hopester 22:52:10 10/26/13 If you're removing the EGR itself, wait until you do the - ThunderZ 09:07:04 10/27/13 FWIW - If you plan to reconnect the EGR system and - jzack 09:55:53 10/27/13 Re: FWIW - If you plan to reconnect the EGR system and - TheDevilZX 14:50:25 10/27/13
Post a Followup	You cannot reply to this message because you are not logged in.