Subject	Re: Re: Re: Re: Re: Re: Let's see if I can help:
Posted by	MaxxAction on October 26, 2013 at 9:05 AM
	This message has been viewed 195 times.
In Reply To	Re: Re: Re: Re: Re: Let's see if I can help: posted by wild_maxx on October 25, 2013 at 09:53 PM
Message	I bought the block off a local guy who is putting an LS motor in his Z. He had the machine work done on it already, and he said they took .010 off the block. I had the heads done myself and he didn't stamp it. And yes, it is an OEM tensioner.
Follow Ups	Decking block and cam timing.. - MaxxAction 16:05:53 10/25/13 Let's see if I can help: - zellamay 18:56:10 10/25/13 Re: Let's see if I can help: - wild_maxx 19:31:45 10/25/13 Re: Re: Let's see if I can help: - MaxxAction 20:14:27 10/25/13 Re: Re: Re: Let's see if I can help: - wild_maxx 21:40:57 10/25/13 Re: Re: Re: Re: Let's see if I can help: - MaxxAction 21:45:01 10/25/13 Re: Re: Re: Re: Re: Let's see if I can help: - wild_maxx 21:53:05 10/25/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 09:05:13 10/26/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 10:10:25 10/26/13 My NA.. - Cjw3 11:15:54 10/26/13 I actually measured all the dimensions out... - -Grimm- 21:11:22 10/26/13 Re: Decking block and cam timing.. - Tech@EPR 04:10:17 10/28/13 By my calculations... - -Grimm- 11:47:43 10/28/13
Post a Followup	You cannot reply to this message because you are not logged in.