Subject	Re: Re: Re: Re: Re: Let's see if I can help:
Posted by	wild_maxx on October 25, 2013 at 9:53 PM
	This message has been viewed 220 times.
In Reply To	Re: Re: Re: Re: Let's see if I can help: posted by MaxxAction on October 25, 2013 at 09:45 PM
Message	That's a good point. I've heard of some people grinding the tensioner as you did but I didn't have to. You're running an OEM tensioner correct? Did your machinist stamp how much he took off the heads and block when he was finished?
Follow Ups	Decking block and cam timing.. - MaxxAction 16:05:53 10/25/13 Let's see if I can help: - zellamay 18:56:10 10/25/13 Re: Let's see if I can help: - wild_maxx 19:31:45 10/25/13 Re: Re: Let's see if I can help: - MaxxAction 20:14:27 10/25/13 Re: Re: Re: Let's see if I can help: - wild_maxx 21:40:57 10/25/13 Re: Re: Re: Re: Let's see if I can help: - MaxxAction 21:45:01 10/25/13 Re: Re: Re: Re: Re: Let's see if I can help: - wild_maxx 21:53:05 10/25/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 09:05:13 10/26/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 10:10:25 10/26/13 My NA.. - Cjw3 11:15:54 10/26/13 I actually measured all the dimensions out... - -Grimm- 21:11:22 10/26/13 Re: Decking block and cam timing.. - Tech@EPR 04:10:17 10/28/13 By my calculations... - -Grimm- 11:47:43 10/28/13
Post a Followup	You cannot reply to this message because you are not logged in.