Subject	Re: Re: Re: Re: Let's see if I can help:
Posted by	MaxxAction on October 25, 2013 at 9:45 PM
	This message has been viewed 184 times.
In Reply To	Re: Re: Re: Let's see if I can help: posted by wild_maxx on October 25, 2013 at 09:40 PM
Message	yeah but I had to grind about 3mm out of the tensioner slots to get a 4mm gap that would hold. I wouldn't have imagined that .030" would make that much difference.
Follow Ups	Decking block and cam timing.. - MaxxAction 16:05:53 10/25/13 Let's see if I can help: - zellamay 18:56:10 10/25/13 Re: Let's see if I can help: - wild_maxx 19:31:45 10/25/13 Re: Re: Let's see if I can help: - MaxxAction 20:14:27 10/25/13 Re: Re: Re: Let's see if I can help: - wild_maxx 21:40:57 10/25/13 Re: Re: Re: Re: Let's see if I can help: - MaxxAction 21:45:01 10/25/13 Re: Re: Re: Re: Re: Let's see if I can help: - wild_maxx 21:53:05 10/25/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 09:05:13 10/26/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 10:10:25 10/26/13 My NA.. - Cjw3 11:15:54 10/26/13 I actually measured all the dimensions out... - -Grimm- 21:11:22 10/26/13 Re: Decking block and cam timing.. - Tech@EPR 04:10:17 10/28/13 By my calculations... - -Grimm- 11:47:43 10/28/13
Post a Followup	You cannot reply to this message because you are not logged in.