Subject	Re: Let's see if I can help:
Posted by	wild_maxx on October 25, 2013 at 7:31 PM
	This message has been viewed 247 times.
In Reply To	Let's see if I can help: posted by zellamay on October 25, 2013 at 06:56 PM
Message	I'm actually going through the process right now after my heads were resurfaced. It appears that the heads have previously resurfaced at one point or my machinist took off more than the .005" he claimed. You'll need a piston stop and a cam degree wheel to verify your cam centerline in relation to the cranks rotation. This may help: [ http://twinturbo.net/nissan/300zx/forums/technical/view/1124020/A-guide-to-VG-cam-degreeing.html ]
Follow Ups	Decking block and cam timing.. - MaxxAction 16:05:53 10/25/13 Let's see if I can help: - zellamay 18:56:10 10/25/13 Re: Let's see if I can help: - wild_maxx 19:31:45 10/25/13 Re: Re: Let's see if I can help: - MaxxAction 20:14:27 10/25/13 Re: Re: Re: Let's see if I can help: - wild_maxx 21:40:57 10/25/13 Re: Re: Re: Re: Let's see if I can help: - MaxxAction 21:45:01 10/25/13 Re: Re: Re: Re: Re: Let's see if I can help: - wild_maxx 21:53:05 10/25/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 09:05:13 10/26/13 Re: Re: Re: Re: Re: Re: Let's see if I can help: - MaxxAction 10:10:25 10/26/13 My NA.. - Cjw3 11:15:54 10/26/13 I actually measured all the dimensions out... - -Grimm- 21:11:22 10/26/13 Re: Decking block and cam timing.. - Tech@EPR 04:10:17 10/28/13 By my calculations... - -Grimm- 11:47:43 10/28/13
Post a Followup	You cannot reply to this message because you are not logged in.