Subject	Just to make sure...
Posted by	-Grimm- on October 24, 2013 at 11:58 AM
	This message has been viewed 193 times.
In Reply To	Start at passenger side and move to the drivers side posted by Woody75 (Denver) on October 24, 2013 at 09:16 AM
Message	Note that cylinder 1 is the US passenger side front. 2 being US drivers side front. At TDC the exhaust valve for that cylinder should be close to opening. It sounds like you're doing it correctly. Are you confident the T belt is on correct (counting teeth is fun). Is the exhaust cam sprocket on correctly? How far apart was your engine (heads specifically) before you began assembly?
Follow Ups	Stock cam degreeing help! - wild_maxx 19:36:54 10/23/13 I haven't read the attached procedure, but... - -Grimm- 20:03:01 10/23/13 Re: I haven't read the attached procedure, but... - wild_maxx 20:29:40 10/23/13 Just some key points to verify - -Grimm- 21:46:13 10/23/13 Re: Just some key points to verify - wild_maxx 06:18:22 10/24/13 Start at passenger side and move to the drivers side - Woody75 (Denver) 09:16:02 10/24/13 Re: Start at passenger side and move to the drivers side - wild_maxx 11:45:57 10/24/13 Just to make sure... - -Grimm- 11:58:20 10/24/13 Re: Just to make sure... - wild_maxx 13:38:09 10/24/13
Post a Followup	You cannot reply to this message because you are not logged in.