Subject	Just some key points to verify
Posted by	-Grimm- on October 23, 2013 at 9:46 PM
	This message has been viewed 178 times.
In Reply To	Re: I haven't read the attached procedure, but... posted by wild_maxx on October 23, 2013 at 08:29 PM
Message	to rule things out... -You are setting TDC (0*) on the same piston for which you are degreeing the exhaust valve on -Your degree wheel is not slipping, pointer is not moving -Your timing marks/tooth count seem correct -You are measuring valve height from the valve itself (and setting 0 at full lift, meaning the 0.050" would be closing motion) Any pictures?
Follow Ups	Stock cam degreeing help! - wild_maxx 19:36:54 10/23/13 I haven't read the attached procedure, but... - -Grimm- 20:03:01 10/23/13 Re: I haven't read the attached procedure, but... - wild_maxx 20:29:40 10/23/13 Just some key points to verify - -Grimm- 21:46:13 10/23/13 Re: Just some key points to verify - wild_maxx 06:18:22 10/24/13 Start at passenger side and move to the drivers side - Woody75 (Denver) 09:16:02 10/24/13 Re: Start at passenger side and move to the drivers side - wild_maxx 11:45:57 10/24/13 Just to make sure... - -Grimm- 11:58:20 10/24/13 Re: Just to make sure... - wild_maxx 13:38:09 10/24/13
Post a Followup	You cannot reply to this message because you are not logged in.