Subject	Re: I haven't read the attached procedure, but...
Posted by	wild_maxx on October 23, 2013 at 8:29 PM
	This message has been viewed 189 times.
In Reply To	I haven't read the attached procedure, but... posted by -Grimm- on October 23, 2013 at 08:03 PM
Message	The issue is the readings I'm getting after rotating to .050" lift CW I'm getting 285*. Going CCW back past 0.0 to .050" I get a reading of 205* which the middle point would end up as 245* right? I must be doing something wrong.
Follow Ups	Stock cam degreeing help! - wild_maxx 19:36:54 10/23/13 I haven't read the attached procedure, but... - -Grimm- 20:03:01 10/23/13 Re: I haven't read the attached procedure, but... - wild_maxx 20:29:40 10/23/13 Just some key points to verify - -Grimm- 21:46:13 10/23/13 Re: Just some key points to verify - wild_maxx 06:18:22 10/24/13 Start at passenger side and move to the drivers side - Woody75 (Denver) 09:16:02 10/24/13 Re: Start at passenger side and move to the drivers side - wild_maxx 11:45:57 10/24/13 Just to make sure... - -Grimm- 11:58:20 10/24/13 Re: Just to make sure... - wild_maxx 13:38:09 10/24/13
Post a Followup	You cannot reply to this message because you are not logged in.