Subject	Boost testing 300degree rail o-rings while motor is out?
Posted by	Jkova300z on October 23, 2013 at 3:44 PM
	This message has been viewed 163 times.
Message	I know that the injector o rings on the 300degree rails where they seal into the Lower plenum sometimes can have a vaccum leak, and even though I'm pretty confident I set them up correctly I would like to boost leak test it before I bolt up the entire motor and start it... Does anyone have a method for this?
Follow Ups	Boost testing 300degree rail o-rings while motor is out? - Jkova300z 15:44:51 10/23/13 Instructions with the rail says to immerse it in - ZTicket(Dallas) 05:47:14 10/25/13 Sounds like tuff to do since the valves that are open>> - ZUL8TR 11:37:53 10/27/13 Got my fixture idea from forum member Cjw3. Search - ZTicket(Dallas) 13:59:13 10/27/13
Post a Followup	You cannot reply to this message because you are not logged in.