Subject	Re: Re: not sure what you did or what your setup is but try
Posted by	MaxxAction on October 22, 2013 at 7:52 AM
	This message has been viewed 316 times.
In Reply To	Re: not sure what you did or what your setup is but try posted by wild_maxx on October 22, 2013 at 06:25 AM
Message	I have a big bubble trapped at the block where the lines separate. It spits fluid out fine, Then once in awhile, (about every fifth or sixth open of the bleeder) I will get a bubble, or some bubbles out. I was doing this in a parking lot so bench bleeding was kinda out of the question. I did let it gravity bleed some before I put the line on, but this thing is pissing me off. The worst it ever was before it only took about an hour.
Follow Ups	I spent 5 hours trying to bleed the clutch... - MaxxAction 21:39:46 10/21/13 not sure what you did or what your setup is but try - Medallion Man 06:22:31 10/22/13 Re: not sure what you did or what your setup is but try - wild_maxx 06:25:18 10/22/13 Re: Re: not sure what you did or what your setup is but try - MaxxAction 07:52:03 10/22/13 Re: Re: Re: not sure what you did or what your setup is but try - Rasta420 09:37:51 10/22/13 Did you try opening up the slave bleed port and just - jzack 11:51:12 10/22/13 Re: Did you try opening up the slave bleed port and just - MaxxAction 12:49:40 10/22/13 Re: Re: Did you try opening up the slave bleed port and just - hopester 19:16:39 10/22/13 Re: I spent 5 hours trying to bleed the clutch... - HKS Z32 16:30:51 10/22/13 Re: Re: I spent 5 hours trying to bleed the clutch... - MaxxAction 18:04:52 10/22/13 Re: I spent 5 hours trying to bleed the clutch... - BlackTwins 00:55:51 10/23/13 Re: Re: I spent 5 hours trying to bleed the clutch... - MaxxAction 07:49:21 10/23/13 I'd change the slave too. Air can get in the line w/o - Gordo 93TT Daytona 22:05:42 10/23/13
Post a Followup	You cannot reply to this message because you are not logged in.