Subject	Re: not sure what you did or what your setup is but try
Posted by	wild_maxx on October 22, 2013 at 6:25 AM
	This message has been viewed 206 times.
In Reply To	not sure what you did or what your setup is but try posted by Medallion Man on October 22, 2013 at 06:22 AM
Message	You need to bench bleed a new master cylinder before you install it.
Follow Ups	I spent 5 hours trying to bleed the clutch... - MaxxAction 21:39:46 10/21/13 not sure what you did or what your setup is but try - Medallion Man 06:22:31 10/22/13 Re: not sure what you did or what your setup is but try - wild_maxx 06:25:18 10/22/13 Re: Re: not sure what you did or what your setup is but try - MaxxAction 07:52:03 10/22/13 Re: Re: Re: not sure what you did or what your setup is but try - Rasta420 09:37:51 10/22/13 Did you try opening up the slave bleed port and just - jzack 11:51:12 10/22/13 Re: Did you try opening up the slave bleed port and just - MaxxAction 12:49:40 10/22/13 Re: Re: Did you try opening up the slave bleed port and just - hopester 19:16:39 10/22/13 Re: I spent 5 hours trying to bleed the clutch... - HKS Z32 16:30:51 10/22/13 Re: Re: I spent 5 hours trying to bleed the clutch... - MaxxAction 18:04:52 10/22/13 Re: I spent 5 hours trying to bleed the clutch... - BlackTwins 00:55:51 10/23/13 Re: Re: I spent 5 hours trying to bleed the clutch... - MaxxAction 07:49:21 10/23/13 I'd change the slave too. Air can get in the line w/o - Gordo 93TT Daytona 22:05:42 10/23/13
Post a Followup	You cannot reply to this message because you are not logged in.