Subject	I've checked the Pics of the IAA. I have the correct
Posted by	ZTicket(Dallas) on October 21, 2013 at 4:21 PM
	This message has been viewed 197 times.
In Reply To	Problem after Plenum Pull. Fixed my air leak caused posted by ZTicket(Dallas) on October 21, 2013 at 12:32 PM
Message	plugs going to the correct solenoids. I have no idea what could be unplugged or plugged in wrong. On that side, the only other plugs I messed with were the driver-side VTC & the driver-side O2 and they are different plugs that can't be switched by mistake. Out of ideas. Hoping you guys might have a few more.
Follow Ups	Problem after Plenum Pull. Fixed my air leak caused - ZTicket(Dallas) 12:32:19 10/21/13 is the timing and TPS adjusted correctly? - Zvil (FL) 13:05:53 10/21/13 Yes neither was disturbed in the Plenum removal - ZTicket(Dallas) 13:17:34 10/21/13 Any corrosion on the connectors? (n/m) - -Grimm- 13:23:51 10/21/13 Negative. New Engine-Bay Harness (2yrs Old) (n/m) - ZTicket(Dallas) 13:26:21 10/21/13 Have you done a boost/vac leak test? - Woody75 (Denver) 13:16:25 10/21/13 Did a boost leak test to varify my insulator repairs - ZTicket(Dallas) 13:25:10 10/21/13 I've checked the Pics of the IAA. I have the correct - ZTicket(Dallas) 16:21:28 10/21/13 Well....Thanks to those that responded. However, - ZTicket(Dallas) 05:28:53 10/22/13 Re: Well....Thanks to those that responded. However, - Rasta420 09:34:34 10/22/13 Yes, I cleand the MAF with the same stuff before I - ZTicket(Dallas) 10:46:04 10/22/13
Post a Followup	You cannot reply to this message because you are not logged in.