Subject	THANKS FELLAS, i got it
Posted by	lukzzkeeper(philly) on October 09, 2013 at 1:48 AM
	This message has been viewed 216 times.
In Reply To	You have to pull down to get it loose from posted by doug8867 on October 08, 2013 at 06:33 AM
Message	I used a pry bar and got it loose from between the ears. Now I got the pomp disassembled I now notice the bearings on the shaft is busted (calling arou-d in am to get replacement). The fear of breaking stuff while working on the Z always get the best of me( things take longer by not using force). Feels good tho.
Follow Ups	removing power steering pump - lukzzkeeper(philly) 13:07:59 10/07/13 Remove the pivot bolt and the adjustment hardware/arm. (n/m) - Woody75 (Denver) 13:17:18 10/07/13 but is that the 14mm bolt - lukzzkeeper(philly) 13:29:44 10/07/13 Bolt is accessed by rotating the belt pulley until the hole - jzack 18:28:18 10/07/13 Re: Bolt is accessed by rotating the belt pulley until the hole - lukzzkeeper(philly) 21:46:16 10/07/13 and a pry bar did nothing? It may be hung up on the - jzack 22:53:10 10/07/13 will try the pry bar when i get off work. (n/m) - lukzzkeeper(philly) 00:23:22 10/08/13 The high pressure hose is disconnect too, right? Had to ask (n/m) - jzack 18:52:12 10/08/13 You have to pull down to get it loose from - doug8867 06:33:52 10/08/13 THANKS FELLAS, i got it - lukzzkeeper(philly) 01:48:41 10/09/13
Post a Followup	You cannot reply to this message because you are not logged in.