Subject	TPS question
Posted by	GotTwins90 on October 07, 2013 at 7:32 PM
	This message has been viewed 192 times.
Message	When I was checking the voltage of the A wire and B wire the A wire kept reading 39ohmns not 0v and when I tried to get a reading from the middle wire so I could adjust it I couldn't get any sort of reading even with a paper clip shoved in it. Any ideas? Thanks
Follow Ups	TPS question - GotTwins90 19:32:39 10/07/13 Sure you had the DVM setup right? It should not be - jzack 22:51:47 10/07/13 Pretty sure haha - GotTwins90 07:43:45 10/08/13 look here.. and try again.. - Medallion Man 05:26:55 10/10/13
Post a Followup	You cannot reply to this message because you are not logged in.