Subject	Ashpecz turbo inlet pipes install
Posted by	PARAZER on September 28, 2013 at 7:19 PM
	This message has been viewed 542 times.
Message	I'm currently in the middle of installing the driver side turbo inlet pipe but can't seem to make it fit. It seems as if the flange on the pipe wont clear the two allen screws that hold the flange that the pipe installs on. Any ideas on how to install the pipe? I currently have MSP manis with heat shields and Z1 GT600R turbos with the engine installed in the car. Any help is appreciated.
Follow Ups	Ashpecz turbo inlet pipes install - PARAZER 19:19:51 09/28/13 Do you have oem motor mounts and did you grind it down? - Evan(CA) 20:59:31 09/29/13 Re: Do you have oem motor mounts and did you grind it down? - PARAZER 22:47:18 09/29/13
Post a Followup	You cannot reply to this message because you are not logged in.