Subject	Are you just doing PM
Posted by	-Grimm- on September 27, 2013 at 9:22 AM
	This message has been viewed 233 times.
In Reply To	Timing belt.. posted by inf on September 26, 2013 at 11:37 PM
Message	Or did you have some machining done? Over-decking the heads will cause that. If you havent machined anything I would do as Zvil said and just count the teeth (Don't most belts come with those white marks these days?)
Follow Ups	Timing belt.. - inf 23:37:55 09/26/13 well.. - inf 00:30:54 09/27/13 I guess my question would be if the crank was rotated - inf 01:01:25 09/27/13 i couldn't even imagine having to count teeth on a quad - inf 01:26:59 09/27/13 just take the belt off and count the teeth then mark it with - Zvil (FL) 08:59:21 09/27/13 Are you just doing PM - -Grimm- 09:22:53 09/27/13 just redid the bearings and rings - inf 12:49:06 09/27/13 Heyyyyyy I'm in the middle of doing that - -Grimm- 13:58:58 09/27/13 Is the tensioner new, and was the "retaining" bolt installed - ZXoltan 16:54:37 09/27/13 new tensioner and I broke the pusher piece off - inf 20:48:48 09/27/13 New NISSAN tensioner? - ZXoltan 21:36:09 09/28/13
Post a Followup	You cannot reply to this message because you are not logged in.