Subject	I guess my question would be if the crank was rotated
Posted by	inf on September 27, 2013 at 1:01 AM
	This message has been viewed 233 times.
In Reply To	well.. posted by inf on September 27, 2013 at 12:30 AM
Message	twice would the markings on the back plate and sprockets align after only matching the sprocket and belt on the installation...hmmm... Guess I'll find out before anyone actually responds, lol.
Follow Ups	Timing belt.. - inf 23:37:55 09/26/13 well.. - inf 00:30:54 09/27/13 I guess my question would be if the crank was rotated - inf 01:01:25 09/27/13 i couldn't even imagine having to count teeth on a quad - inf 01:26:59 09/27/13 just take the belt off and count the teeth then mark it with - Zvil (FL) 08:59:21 09/27/13 Are you just doing PM - -Grimm- 09:22:53 09/27/13 just redid the bearings and rings - inf 12:49:06 09/27/13 Heyyyyyy I'm in the middle of doing that - -Grimm- 13:58:58 09/27/13 Is the tensioner new, and was the "retaining" bolt installed - ZXoltan 16:54:37 09/27/13 new tensioner and I broke the pusher piece off - inf 20:48:48 09/27/13 New NISSAN tensioner? - ZXoltan 21:36:09 09/28/13
Post a Followup	You cannot reply to this message because you are not logged in.