Subject	well..
Posted by	inf on September 27, 2013 at 12:30 AM
	This message has been viewed 285 times.
In Reply To	Timing belt.. posted by inf on September 26, 2013 at 11:37 PM
Message	I researched high and low and haven't found anyone else with this issue... I guess I'll just have to match the sprockets with the belt and forget about trying to stretch and pull it over to make it reach to back plate marks...guess I'll be countin' away...yay.
Follow Ups	Timing belt.. - inf 23:37:55 09/26/13 well.. - inf 00:30:54 09/27/13 I guess my question would be if the crank was rotated - inf 01:01:25 09/27/13 i couldn't even imagine having to count teeth on a quad - inf 01:26:59 09/27/13 just take the belt off and count the teeth then mark it with - Zvil (FL) 08:59:21 09/27/13 Are you just doing PM - -Grimm- 09:22:53 09/27/13 just redid the bearings and rings - inf 12:49:06 09/27/13 Heyyyyyy I'm in the middle of doing that - -Grimm- 13:58:58 09/27/13 Is the tensioner new, and was the "retaining" bolt installed - ZXoltan 16:54:37 09/27/13 new tensioner and I broke the pusher piece off - inf 20:48:48 09/27/13 New NISSAN tensioner? - ZXoltan 21:36:09 09/28/13
Post a Followup	You cannot reply to this message because you are not logged in.