Subject	Re: You ever tried using ACL racing bearing?
Posted by	Tech@EPR on September 23, 2013 at 7:38 PM
	This message has been viewed 287 times.
In Reply To	You ever tried using ACL racing bearing? posted by Z-speed on September 20, 2013 at 08:20 AM
Message	My experience is that they fatigue much easier than the Clevite,Federal Mogul or KING bearings that I normally use. Im not a huge fan of the ACL bearings but on some applications ACL is the only choice sadly. I can do a comparison write up on bearings at some point in time..I just have to get a free moment to get a set from each manufacture and sit down and do some investigating. I have an MLS headgasket comparison I have to do a write up on soon. Ep Racing | Create Your Badge
Follow Ups	Bearing Condition - Your Opinion - -Grimm- 09:26:46 09/19/13 All looks fine to me - Cjw3 11:30:39 09/19/13 Whole engine it out. - -Grimm- 12:11:39 09/19/13 Might want to search the Water Jacket Cleaning - Cjw3 12:38:03 09/19/13 I have a degree wheel - -Grimm- 14:23:35 09/19/13 Aluminum Foil is an old time trick - Cjw3 15:42:19 09/19/13 Interesting, I'll have to see what mine measure... - -Grimm- 16:51:35 09/19/13 Shim Shots.. - Cjw3 17:31:25 09/19/13 LOL foil in the motor sounds and is terrible...... - Nis300owner 00:51:57 09/22/13 It's an old school thing.. - Cjw3 14:45:42 09/22/13 Re: It's an old school thing.. - Tech@EPR 19:48:16 09/23/13 Re: Bearing Condition - Your Opinion - Tech@EPR 04:03:06 09/20/13 You ever tried using ACL racing bearing? - Z-speed 08:20:42 09/20/13 Re: You ever tried using ACL racing bearing? - Tech@EPR 19:38:04 09/23/13 Makes sense, previous owner had the det sensor bypassed - -Grimm- 09:55:25 09/20/13 Re: Makes sense, previous owner had the det sensor bypassed - Tech@EPR 13:21:12 09/20/13 So, although my block stamps say there is some variance - -Grimm- 16:06:25 09/20/13 Re: So, although my block stamps say there is some variance - Tech@EPR 21:24:27 09/20/13 Does anyone know the thickness of the bearings by grade? - -Grimm- 10:27:11 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.