Subject	Re: Makes sense, previous owner had the det sensor bypassed
Posted by	Tech@EPR on September 20, 2013 at 1:21 PM
	This message has been viewed 276 times.
In Reply To	Makes sense, previous owner had the det sensor bypassed posted by -Grimm- on September 20, 2013 at 09:55 AM
Message	I tossed stock oil clearances in the trash. Suggested clearances are extremely too tight. Std bearing from aftermarket suppliers are still consistent with each other. They run the loose side as well which is great. Ep Racing | Create Your Badge
Follow Ups	Bearing Condition - Your Opinion - -Grimm- 09:26:46 09/19/13 All looks fine to me - Cjw3 11:30:39 09/19/13 Whole engine it out. - -Grimm- 12:11:39 09/19/13 Might want to search the Water Jacket Cleaning - Cjw3 12:38:03 09/19/13 I have a degree wheel - -Grimm- 14:23:35 09/19/13 Aluminum Foil is an old time trick - Cjw3 15:42:19 09/19/13 Interesting, I'll have to see what mine measure... - -Grimm- 16:51:35 09/19/13 Shim Shots.. - Cjw3 17:31:25 09/19/13 LOL foil in the motor sounds and is terrible...... - Nis300owner 00:51:57 09/22/13 It's an old school thing.. - Cjw3 14:45:42 09/22/13 Re: It's an old school thing.. - Tech@EPR 19:48:16 09/23/13 Re: Bearing Condition - Your Opinion - Tech@EPR 04:03:06 09/20/13 You ever tried using ACL racing bearing? - Z-speed 08:20:42 09/20/13 Re: You ever tried using ACL racing bearing? - Tech@EPR 19:38:04 09/23/13 Makes sense, previous owner had the det sensor bypassed - -Grimm- 09:55:25 09/20/13 Re: Makes sense, previous owner had the det sensor bypassed - Tech@EPR 13:21:12 09/20/13 So, although my block stamps say there is some variance - -Grimm- 16:06:25 09/20/13 Re: So, although my block stamps say there is some variance - Tech@EPR 21:24:27 09/20/13 Does anyone know the thickness of the bearings by grade? - -Grimm- 10:27:11 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.