Subject	Re: Bearing Condition - Your Opinion
Posted by	Tech@EPR on September 20, 2013 at 4:03 AM
	This message has been viewed 370 times.
In Reply To	Bearing Condition - Your Opinion posted by -Grimm- on September 19, 2013 at 09:26 AM
Message	you have a bunch of bearing fatigue going on with both rods and mains. Also looking at the rod bearings, they experienced some detonation at some point in their life cycle. The mains suffered from too tight of clearance as well. I would highly suggest running a set of STD Clevite bearings on this go around. They are generous on oil clearance and the STD size works very well with original equipment. Good luck Ep Racing | Create Your Badge
Follow Ups	Bearing Condition - Your Opinion - -Grimm- 09:26:46 09/19/13 All looks fine to me - Cjw3 11:30:39 09/19/13 Whole engine it out. - -Grimm- 12:11:39 09/19/13 Might want to search the Water Jacket Cleaning - Cjw3 12:38:03 09/19/13 I have a degree wheel - -Grimm- 14:23:35 09/19/13 Aluminum Foil is an old time trick - Cjw3 15:42:19 09/19/13 Interesting, I'll have to see what mine measure... - -Grimm- 16:51:35 09/19/13 Shim Shots.. - Cjw3 17:31:25 09/19/13 LOL foil in the motor sounds and is terrible...... - Nis300owner 00:51:57 09/22/13 It's an old school thing.. - Cjw3 14:45:42 09/22/13 Re: It's an old school thing.. - Tech@EPR 19:48:16 09/23/13 Re: Bearing Condition - Your Opinion - Tech@EPR 04:03:06 09/20/13 You ever tried using ACL racing bearing? - Z-speed 08:20:42 09/20/13 Re: You ever tried using ACL racing bearing? - Tech@EPR 19:38:04 09/23/13 Makes sense, previous owner had the det sensor bypassed - -Grimm- 09:55:25 09/20/13 Re: Makes sense, previous owner had the det sensor bypassed - Tech@EPR 13:21:12 09/20/13 So, although my block stamps say there is some variance - -Grimm- 16:06:25 09/20/13 Re: So, although my block stamps say there is some variance - Tech@EPR 21:24:27 09/20/13 Does anyone know the thickness of the bearings by grade? - -Grimm- 10:27:11 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.