Subject	Whole engine it out.
Posted by	-Grimm- on September 19, 2013 at 12:11 PM
	This message has been viewed 271 times.
In Reply To	All looks fine to me posted by Cjw3 on September 19, 2013 at 11:30 AM
Message	Figured if I have it this far apart I might as well fully rebuild it (albeit to stock) Goes in the hot tank tonight, hone, rering and new bearings. Heads are at the shop being reground and reseated (as necessary) Thanks for your input, that's what I was hoping. Head gasket was block after the car overheated, although the previous owner claims he shut the car off before it died on its own so that's a good thing.
Follow Ups	Bearing Condition - Your Opinion - -Grimm- 09:26:46 09/19/13 All looks fine to me - Cjw3 11:30:39 09/19/13 Whole engine it out. - -Grimm- 12:11:39 09/19/13 Might want to search the Water Jacket Cleaning - Cjw3 12:38:03 09/19/13 I have a degree wheel - -Grimm- 14:23:35 09/19/13 Aluminum Foil is an old time trick - Cjw3 15:42:19 09/19/13 Interesting, I'll have to see what mine measure... - -Grimm- 16:51:35 09/19/13 Shim Shots.. - Cjw3 17:31:25 09/19/13 LOL foil in the motor sounds and is terrible...... - Nis300owner 00:51:57 09/22/13 It's an old school thing.. - Cjw3 14:45:42 09/22/13 Re: It's an old school thing.. - Tech@EPR 19:48:16 09/23/13 Re: Bearing Condition - Your Opinion - Tech@EPR 04:03:06 09/20/13 You ever tried using ACL racing bearing? - Z-speed 08:20:42 09/20/13 Re: You ever tried using ACL racing bearing? - Tech@EPR 19:38:04 09/23/13 Makes sense, previous owner had the det sensor bypassed - -Grimm- 09:55:25 09/20/13 Re: Makes sense, previous owner had the det sensor bypassed - Tech@EPR 13:21:12 09/20/13 So, although my block stamps say there is some variance - -Grimm- 16:06:25 09/20/13 Re: So, although my block stamps say there is some variance - Tech@EPR 21:24:27 09/20/13 Does anyone know the thickness of the bearings by grade? - -Grimm- 10:27:11 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.