Subject	I have both (Mic's and unexpired plastigauge)
Posted by	-Grimm- on September 19, 2013 at 9:23 AM
	This message has been viewed 188 times.
In Reply To	be sure to check the clearance before and afterwards posted by soulpwr on September 19, 2013 at 01:44 AM
Message	Always better double checking than finding out the hard way. I'm going to post a new picture with pictures of the bearings to see if anyone sees anything abnormal (moreso than myself) Thanks
Follow Ups	Connecting Rod Bearing Grade Stamps - -Grimm- 16:50:31 09/15/13 Picture of it - -Grimm- 19:07:20 09/15/13 be sure to check the clearance before and afterwards - soulpwr 01:44:08 09/19/13 I have both (Mic's and unexpired plastigauge) - -Grimm- 09:23:53 09/19/13 Look at the back of the crankshaft for the rod bearing - ztunerz 00:28:55 09/16/13 So you're saying the G doesn't matter? - -Grimm- 09:23:11 09/16/13 Crank says f on the front lobe. All rods I have seen - ztunerz 00:34:20 09/17/13 I'll take your word for it - -Grimm- 09:15:06 09/17/13
Post a Followup	You cannot reply to this message because you are not logged in.