Subject	So you're saying the G doesn't matter?
Posted by	-Grimm- on September 16, 2013 at 9:23 AM
	This message has been viewed 200 times.
In Reply To	Look at the back of the crankshaft for the rod bearing posted by ztunerz on September 16, 2013 at 12:28 AM
Message	The only similar reference I could find was that every rod would have an 'F' stamped into it. Nothing about a G though. Anyone else have a G on their rods? If not I'll just follow the FSM and pretend it isn't there.
Follow Ups	Connecting Rod Bearing Grade Stamps - -Grimm- 16:50:31 09/15/13 Picture of it - -Grimm- 19:07:20 09/15/13 be sure to check the clearance before and afterwards - soulpwr 01:44:08 09/19/13 I have both (Mic's and unexpired plastigauge) - -Grimm- 09:23:53 09/19/13 Look at the back of the crankshaft for the rod bearing - ztunerz 00:28:55 09/16/13 So you're saying the G doesn't matter? - -Grimm- 09:23:11 09/16/13 Crank says f on the front lobe. All rods I have seen - ztunerz 00:34:20 09/17/13 I'll take your word for it - -Grimm- 09:15:06 09/17/13
Post a Followup	You cannot reply to this message because you are not logged in.