Subject	Help... Front ball joint
Posted by	Va5hTheStampede on September 13, 2013 at 10:16 PM
	This message has been viewed 245 times.
Message	so I removed my front lower control arms on my 1990 z, I had a shop press in the new ball joint. I compared the old ball joints with the new ones, everything looked same, I installed the LCA back on the car, everything was fine but when I went to start my car and pulled forward my front wheels opened up in opposite ways, drivers side was totally turned left and passenger was turned all the way right,... I immediately lifted the front wheels, checked my tie rods, steering rack shock mount etc., the only thing I noticed was that the ball joint had a lot of play. I tightened the nut on top of the ball joint and it has about 3/4 of an inch of room to slide before it hits the spindle, please help idk if im missing washers, I don't remember throwing anything away. thankz
Follow Ups	Help... Front ball joint - Va5hTheStampede 22:16:13 09/13/13 Re: Help... Front ball joint - njz 06:05:03 09/15/13 Connect the tie rods too (n/m) - njz 06:08:24 09/15/13 Re: Help... Front ball joint - Va5hTheStampede 15:22:12 09/15/13
Post a Followup	You cannot reply to this message because you are not logged in.