Subject	If you study the Fixture
Posted by	Cjw3 on September 12, 2013 at 9:00 PM
	This message has been viewed 161 times.
In Reply To	Makes sense that you would have to make a fixture posted by ZTicket(Dallas) on September 12, 2013 at 07:38 PM
Message	You will see 6 Holes.. Two in the Center back that will line up with the Narrower Back hole Set.. then the "Repeat 4" that are used by the Others.. I think it was 3/8 Alumn Plate.. 1/4 will work.. and notice the sides are 'Blended' to fit around the injectors.. The Fixture will do two Cylinders at a Time.. each Cylinder has it's own 'Pressure Port'.. I ended up using Vacuum, as I do A/c work, and it's faster for me to Vacuum Check.. But it's the same thing.. Cj
Follow Ups	Found intake manifold leak next to number 1 runner. I'm - ZTicket(Dallas) 06:20:41 09/12/13 Engine Parts Move.. - Cjw3 11:55:37 09/12/13 Re: Engine Parts Move.. - Cjw3 17:55:37 09/12/13 Makes sense that you would have to make a fixture - ZTicket(Dallas) 19:38:02 09/12/13 If you study the Fixture - Cjw3 21:00:00 09/12/13 whats that thing on you fuel rail? - toykoz32 01:28:49 09/14/13 I Silver Soldered in a Schrader Extension. - Cjw3 06:27:35 09/14/13
Post a Followup	You cannot reply to this message because you are not logged in.