Subject	These are the mods for this build.
Posted by	z32z on September 10, 2013 at 7:32 AM
	This message has been viewed 336 times.
In Reply To	Spark and fuel is there. (n/m) posted by z32z on September 09, 2013 at 08:44 PM
Message	Built Engine *Ash "Tweaked" Gt2860rs *Ash Planar Pipes *3" Sz expansion pipes *Ash 2.5" intercooler Piping *Ash Massives V3 w/ Ducts *Msp Manifolds *3" Downpipes *3"-2.5" Testpipes *Sz High 5 Puck Clutch *Sz Lightweight Flywheel *Heavy Duty Fork Kit *Chromoly pivot ball *850cc Border Kit *Aeramotive fuel pressure reg *Selin Translator *Dual MAF *Dual Apexi intakes *Greddy Rz bovs *Wiring Specialtys Harness *Inland 1 Piece Driveshaft *Bde Low Pro Motor Mounts *Snow Performance Water Meth I may be forgetting a few things.
Follow Ups	Found a small piece of metal in cylinder #3. - z32z 19:26:49 09/09/13 The thread from the block? - 300ZMang 19:57:23 09/09/13 Thinking it's a thread from the Intake Manifold somewhere. - Cjw3 20:39:07 09/09/13 Spark and fuel is there. (n/m) - z32z 20:44:53 09/09/13 Change the Plugs, use Starting Fluid.. - Cjw3 21:56:36 09/09/13 What do you do about air pockets in the fuel line ? - z32z 07:24:02 09/10/13 Once it runs, they flush out.. - Cjw3 10:57:46 09/10/13 These are the mods for this build. - z32z 07:32:03 09/10/13 Re: Thinking it's a thread from the Intake Manifold somewhere. - wild_maxx 20:45:44 09/09/13 Spark plug hole thread. (n/m) - DVDBURN (MD) 10:54:59 09/10/13 This is what I meant, guess I didn't use proper terms (n/m) - 300ZMang 12:13:10 09/10/13 Part of piston pin circlip? Does it bend? - ZXoltan 21:27:06 09/10/13 2x to these questions. If it is magnetic then it can't - boileralum 13:45:15 09/11/13 it is magnetic. (n/m) - z32z 20:00:13 09/11/13 Maybe part of a heli-coil from a balance tube hole or - Evan_Wright (Ca) 23:44:46 09/11/13
Post a Followup	You cannot reply to this message because you are not logged in.