Subject	Thinking it's a thread from the Intake Manifold somewhere.
Posted by	Cjw3 on September 09, 2013 at 8:39 PM
	This message has been viewed 259 times.
In Reply To	Found a small piece of metal in cylinder #3. posted by z32z on September 09, 2013 at 07:26 PM
Message	I'd take a peek with a Bore Scope if available.. Not necessarily Fatal to the engine.. Do a leak down test to see if you just might have some more of it under a valve.. then see if you can wash it out before firing.. else the Flames will blow it out.. Pull the CAS then spin it with the key on.. see if you have spark and fuel.. Cj
Follow Ups	Found a small piece of metal in cylinder #3. - z32z 19:26:49 09/09/13 The thread from the block? - 300ZMang 19:57:23 09/09/13 Thinking it's a thread from the Intake Manifold somewhere. - Cjw3 20:39:07 09/09/13 Spark and fuel is there. (n/m) - z32z 20:44:53 09/09/13 Change the Plugs, use Starting Fluid.. - Cjw3 21:56:36 09/09/13 What do you do about air pockets in the fuel line ? - z32z 07:24:02 09/10/13 Once it runs, they flush out.. - Cjw3 10:57:46 09/10/13 These are the mods for this build. - z32z 07:32:03 09/10/13 Re: Thinking it's a thread from the Intake Manifold somewhere. - wild_maxx 20:45:44 09/09/13 Spark plug hole thread. (n/m) - DVDBURN (MD) 10:54:59 09/10/13 This is what I meant, guess I didn't use proper terms (n/m) - 300ZMang 12:13:10 09/10/13 Part of piston pin circlip? Does it bend? - ZXoltan 21:27:06 09/10/13 2x to these questions. If it is magnetic then it can't - boileralum 13:45:15 09/11/13 it is magnetic. (n/m) - z32z 20:00:13 09/11/13 Maybe part of a heli-coil from a balance tube hole or - Evan_Wright (Ca) 23:44:46 09/11/13
Post a Followup	You cannot reply to this message because you are not logged in.