Subject	I recognize that diagram...
Posted by	-Grimm- on September 09, 2013 at 11:23 AM
	This message has been viewed 158 times.
In Reply To	Re: Boost controller hose routing posted by Exia on September 08, 2013 at 11:29 PM
Message	Oh yeah. That's how mine is hooked up also. The air fed to the boost controller is going to be pretty static, so one vs. two hoses wont have any great differences. The only thing I could possibly imagine being different is if you have one turbo (that you are metering pressure from) fail, the sensor will see a lower pressure than the other turbo is putting out. This can be avoided by using the plugged port on the rear, PS of the manifold (next to the balance tube). I figure at this point the driver will definitely know something is up and fix it.
Follow Ups	Boost controller hose routing - Bad Fish 13:43:16 09/07/13 Re: Boost controller hose routing - Exia 23:29:59 09/08/13 I recognize that diagram... - -Grimm- 11:23:48 09/09/13 Re: I recognize that diagram... - Bad Fish 18:08:29 09/09/13 I bet hose length would be negligible - -Grimm- 13:22:14 09/10/13
Post a Followup	You cannot reply to this message because you are not logged in.