Subject	Set the TPS Voltage to .45 Volts
Posted by	Cjw3 on September 05, 2013 at 8:36 PM
	This message has been viewed 182 times.
In Reply To	Idle Issue While at Operating Temp posted by 1990Z32Guy on September 05, 2013 at 07:02 PM
Message	Then UN-Plug the Sensor ( the dangly part) for a few minutes.. then plug back in. It should settle down.. It Sounds like it is not settling into Idle Mode.. Cj
Follow Ups	Idle Issue While at Operating Temp - 1990Z32Guy 19:02:49 09/05/13 You've verified the coolant sensor is operating in spec? - jzack 19:12:35 09/05/13 Re: You've verified the coolant sensor is operating in spec? - 1990Z32Guy 19:44:48 09/05/13 Don't assume - test it per the FSM..... (n/m) - jzack 21:17:21 09/05/13 Set the TPS Voltage to .45 Volts - Cjw3 20:36:38 09/05/13 Re: Set the TPS Voltage to .45 Volts - 1990Z32Guy 21:25:56 09/05/13 Re: Re: Set the TPS Voltage to .45 Volts - 1990Z32Guy 21:36:42 09/05/13 You have to Unplug the Sensor.. - Cjw3 21:43:42 09/05/13
Post a Followup	You cannot reply to this message because you are not logged in.