Subject	good rule of thumb is .001" per inch of journal diameter
Posted by	aliaZ on August 29, 2013 at 1:38 PM
	This message has been viewed 125 times.
In Reply To	Preferred bearing clearances posted by ttsmokin on August 27, 2013 at 10:51 PM
Message	the low end of the specs in the FSM are too tight for performance applications
Follow Ups	Preferred bearing clearances - ttsmokin 22:51:34 08/27/13 good rule of thumb is .001" per inch of journal diameter - aliaZ 13:38:35 08/29/13
Post a Followup	You cannot reply to this message because you are not logged in.