TwinTurbo.NET: Nissan 300ZX forum - Re: I bet you got a ripped coupler somewhere
People Seeking Info
 
   


     
Subject Re: I bet you got a ripped coupler somewhere
     
Posted by TwinTurboByrd on August 28, 2013 at 9:03 AM
  This message has been viewed 208 times.
     
In Reply To I bet you got a ripped coupler somewhere posted by Carlos Ramirez on August 28, 2013 at 08:42 AM
     
Message Well, Ive been running with the wastegates just unhooked. Solenoids in place, and no hoses ran to the wastegates. I eliminated the solenoids completely, and ran lines to the wastegates. As I was running the new hoses I noticed someone had gooped silicone down into the nipples on the hard pipes. I removed the silicon, ran my lines, and installed .035 boost jets. Car shoots up to 7psi FAST, but, stays there, wont go any higher....the day before with just straight hoses ran to the WG's the car made 12psi but was sluggish getting there. So even though I was pretty sure .035 jets were what I needed I decided to pull them and try another size...as I was pulling them I decided to do another test run before the putting in more jets. Same thing, 7psi, no higher. Keep in mind, theyre gt525 turbos with 12psi WG's. Any ideas????

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.