Subject	would it be the case of the engine being able to compress
Posted by	inf on August 26, 2013 at 10:18 PM
	This message has been viewed 169 times.
In Reply To	Bad leakdown, good compression posted by inf on August 26, 2013 at 09:55 PM
Message	the air to an acceptable psi due to the nature of the test? That is, the engine can compress the air well, but as far as containing it after it's compressed it'll immediately leak out due to the intake valve not seating? Is it possible a valve guide is bad on that cylinder and not letting the intake valve seat properly, but upon a compression test the multiple rotations of the engine give it enough chances to seat decently?
Follow Ups	Bad leakdown, good compression - inf 21:55:48 08/26/13 Weak valve spring? (n/m) - jzack 22:11:39 08/26/13 would it be the case of the engine being able to compress - inf 22:18:54 08/26/13 If I remember correctly this was the cylinder that took - inf 22:30:22 08/26/13 hmm...maybe carbon deposits on the valve... - inf 01:30:51 08/27/13 Re: hmm...maybe carbon deposits on the valve... - wild_maxx 07:16:50 08/27/13 not sure, it's a used engine that hasn't been installed yet - inf 10:39:44 08/27/13 regardless, I can clearly see oil bubbles forming on - inf 11:20:52 08/27/13 hmm, cylinder 4 sucks too... - inf 11:34:52 08/27/13 i just did another compression test on 4 and 6... - inf 14:33:29 08/27/13
Post a Followup	You cannot reply to this message because you are not logged in.