Subject	i think i remember how i did it before
Posted by	inf on August 23, 2013 at 11:12 PM
	This message has been viewed 211 times.
In Reply To	Trying to bench compression test an engine posted by inf on August 23, 2013 at 08:40 PM
Message	I used a paper clip and touched the big and small posts together but that still doesnt make sense since it doesnt do this on the car...or maybe im forgetting something
Follow Ups	Trying to bench compression test an engine - inf 20:40:40 08/23/13 Should I be connecting the little connector part of the - inf 20:47:46 08/23/13 I can also spin it by hand no problem. (n/m) - inf 21:12:51 08/23/13 perhaps the starter is on the transmission too tight..hmm... (n/m) - inf 21:40:43 08/23/13 i think i remember how i did it before - inf 23:12:07 08/23/13 Hmm...would having an engine from an auto and using - inf 14:46:49 08/24/13 it looks like the starter gear gets stuck after it tries to - inf 14:53:40 08/24/13 Did you put a manual flywheel on? - ZXoltan 18:07:22 08/24/13 ya, the manual flywheel is on... (n/m) - inf 20:45:59 08/24/13 Also, flywheel must be for NA if u are using NA tranny - ZXoltan 07:42:49 08/26/13 the starter can't even get past compressing one cylinder - inf 20:49:17 08/24/13 You are not getting enough juice (electrical power). - zellamay 20:58:02 08/24/13 ya i just and I mean just read someone elses reply - inf 20:59:55 08/24/13 When jumping cars, I've had the experience of cheap - zellamay 23:52:52 08/24/13 i used thicker cables, like twice as big and got it goin... - inf 22:35:37 08/26/13
Post a Followup	You cannot reply to this message because you are not logged in.