Subject	I can also spin it by hand no problem. (n/m)
Posted by	inf on August 23, 2013 at 9:12 PM
	This message has been viewed 172 times.
In Reply To	Trying to bench compression test an engine posted by inf on August 23, 2013 at 08:40 PM
Message
Follow Ups	Trying to bench compression test an engine - inf 20:40:40 08/23/13 Should I be connecting the little connector part of the - inf 20:47:46 08/23/13 I can also spin it by hand no problem. (n/m) - inf 21:12:51 08/23/13 perhaps the starter is on the transmission too tight..hmm... (n/m) - inf 21:40:43 08/23/13 i think i remember how i did it before - inf 23:12:07 08/23/13 Hmm...would having an engine from an auto and using - inf 14:46:49 08/24/13 it looks like the starter gear gets stuck after it tries to - inf 14:53:40 08/24/13 Did you put a manual flywheel on? - ZXoltan 18:07:22 08/24/13 ya, the manual flywheel is on... (n/m) - inf 20:45:59 08/24/13 Also, flywheel must be for NA if u are using NA tranny - ZXoltan 07:42:49 08/26/13 the starter can't even get past compressing one cylinder - inf 20:49:17 08/24/13 You are not getting enough juice (electrical power). - zellamay 20:58:02 08/24/13 ya i just and I mean just read someone elses reply - inf 20:59:55 08/24/13 When jumping cars, I've had the experience of cheap - zellamay 23:52:52 08/24/13 i used thicker cables, like twice as big and got it goin... - inf 22:35:37 08/26/13
Post a Followup	You cannot reply to this message because you are not logged in.